It doesn't get easier than this: Apply Clickguard™ to the top of the tongues, lengths and widths of the panels. Assemble the panels. After 15-25 minutes, peel off the excess sealant. The installation is complete.

Instructions for use: Clickguard™ may be applied to all glueless flooring systems, both laminate and hardwood. Follow installation directions provided by the flooring manufacturer; then take the following steps:

Before fitting boards together, apply Clickguard™ to all board tongue edges, both sides and ends. Make sure to apply a generous quantity of Clickguard™ to top of tongue to ensure a complete, even seal. Connect boards together immediately after application. Do not allow Clickguard™ to dry before locking boards. Wait approximately 20 minutes and then remove any surplus from top of boards with a plastic spatula. Should any dried residue need further attention, wipe the area with a solvent. Self-locking floors sealed with Clickguard™ may be installed in all living and commercial areas including moisture prone areas such as kitchens, entrances, and utility areas. During the life of the floor, any damaged boards may be removed and replaced because Clickguard™ always remains flexible.

To download the instructions in PDF format, please visit our
Download area.